Operating an Inverted MAG Drill

Operating an Inverted MAG Drill

Hi again...

Not for the faint of heart... but when you are working on elevated heavy iron, you sometime have to drill holes inverted.... placement of the mag drill is not easy and on top of that you have to stop periodically to add cutting fluid to the flutes. The trick is to take your time.

Dr. Fab.

We design, engineer, and fabricate just about anything.


Older Post
Newer Post

Leave a comment

Please note, comments must be approved before they are published

Close (esc)

Age verification

By clicking enter you are verifying that you are old enough to consume alcohol.


Shopping Cart

Your cart is currently empty.
Shop now